LEAP 3.0: No boot device on Cleartouch
New Cleartouch LEAP Boards that arrive with an unresponsive PC may need an adjustment made in the computer firmware before its first boot. If you cannot reach a Windows desktop from the LEAP board, please perform the following steps:
- If the Cleartouch TV is ON, power it off by holding down the power button until the following prompt appears:
- Press OK or allow the TV and PC to fully power down.
- Once powered off perform the following sequence to enter the computer BIOS:
- Press the Power Button on the TV one time while continually pressing F2 on the remote (at a rate of about twice per second)
- You will see a screen that looks like this:
- Using the remote, move to the Save & Exit tab and choose Restore Defaults.
- Load Optimized Defaults? Choose Yes.
- Now select Save Changes and Reset.
- Your TV and PC should now reset. If you still don't see a Windows desktop, use the Source button on the remote to ensure that you are on the PC input.