Door Access - Controller Reboot

This guide provides step-by-step instructions for resetting the Axis A1601 door controller and its attached Wavelynx readers by performing a power cycle. This process can help resolve connectivity issues or restore functionality to the controller and connected devices.

Prerequisites

Access to the Controller: Ensure you can safely open the lid of the Axis A1601 controller to access its internal components.
Tools: a torx security screwdriver (T20H) which would have come with the Axis A1601 controllers in the box.

Step-by-Step Instructions

1. Turn Off Battery Backup

Locate the battery backup system inside the controller.
Press and hold its power button for approximately 10 seconds to ensure no power is being sent to the system.

2. Open the Controller Lid

Loosen the screw on the lid until you can open the lid of the Axis A1601 controller to access the internal panel.

3. Disconnect Reader Blocks

Locate the two reader blocks inside the controller (typically positioned on the left side).
Pull out both blocks to disconnect the readers from the controller.

4. Disconnect Ethernet Cable

Remove the Ethernet cable from its port on the controller to reset network connectivity.

5. Unplug External Power Source

Find the external power source (usually a black connector at the top of the panel)
Unplug this connector to fully power down the unit.

6. Wait

Allow a few seconds for all components to fully discharge before reconnecting them.

7. Reconnect Components

Reinsert both reader blocks.
Turn on the battery backup by pressing its power button.
Reconnect the Ethernet cable.
Plug in the external power source.

Once completed please check that the system function has returned to normal by confirming that all doors unlock using a phone and fob, as well as verifying that new credentials are able to sync.